Car PDR Tools- Paintless Dent Repair Bridge Removal Kit+Vehicle Hot Melt Glue Gun 100W Pulling Bridge Set+3pcs x Glue Sticks

  • $25.00
    Unit price per 
  • Save $10
Tax included. Shipping calculated at checkout.


Car PDR Tools- Paintless Dent Repair Bridge Removal Kit+Vehicle Hot Melt Glue Gun 100W Pulling Bridge Set+3pcs x Glue Sticks

Features:

Repairs dents in almost any place on any vehicle.Easily removes dents from hail. Car doors, shopping carts and more without damaging the surface of your car

Usage method:
1. clean the damaged surface with mop before repairing.
2. Heat the glue stick in the gun for 5 minutes before usage.
3. Match the glue pad with the size of dent. the larger the pad, the greater is the pulling force.
4. Apply a generous amount of hot glue from the hot melt gun on the selected pad covering the entire surface of the pad. Be sure all the 4 holes are covered.
5. Immediately place pad in the center of dented place until it sticks by itself. Let glue dry approximately 3-5 minutes. The glue will be firm.
CAUTION: DO NOT LET GLUE DRY ON VEHICLE LONGER THAN 8 MINUTES.
6. Place the stem of the pad through the hole in the pulling bridge and screw on the knob. Tighten the knob until the pad pops off.
7. Repeat process until dent is level with surface

aeProduct.getSubject()aeProduct.getSubject()aeProduct.getSubject()aeProduct.getSubject()aeProduct.getSubject()

aeProduct.getSubject()aeProduct.getSubject()

Package Contents:

1pcs*Glue Gun

1Set*Pulling Bridge with 7*Suction Cup

3pcs*Glue Sticks


 

How to repair , seen the step:

1:use alcohol with cloth Clean the dent place
2:Glue gun (with glue stick) Plug in the power supply , wait 3-5 minute (if you not have the Glue gun , you can buy in our store)
3:choose the right black dent tabs ,and apply glue full in the tabs ( have 7 size dent tabs to choose ,more big dent need use more big dent tabs)
4:use black dent tabs fixed at dent place
5:use the pdr pulling bridge Screw holes Align the black tabs, screw the cap onto the tabs and tighten it tight, tighten the screw cap until the small pit is repaired
6: repair ok later ,Twist off the nut , take out the pulling bridge , use the alcohol and  rubber scraper clean the glue
 
Note: If the above repair is not repaired successfully, please repeat the repair again
1:If the surface after repair has raised point, you can use the thumb presses the bump
2: use the use the thumb presses the bump also not have effect , you can try our store Dent Removal Pen ,if you need you can buy in our store ,thank you!


We Also Recommend